The device that I will inform you concerning is for utilizing herbicides like RoundUp. The greatest missteps that individuals make when utilizing non-specific herbicides like RoundUp is overspray getting the herbicide on plants that they didn’t mean to shower, and over applying the item. In the event that you splash to the place of run unique weed pipes, you are applying an excessive lot.

The weed dabber is an apparatus utilized for spot treating weeds without getting the herbicide on different plants.

Start by going to your tool shop and purchasing a piece of 1-1/2″ PVC pipe. You just need a piece 30″ long, yet they may make you purchase a 10′ area. It’s quite modest however. You’ll require a plastic PVC cap for one finish of the line, and on the opposite end you’ll require a connector to change over the PVC line to a standard line string. You’ll need to let the assistant at the tool shop help you track down the best mix of fittings to utilize. What you need to do is to get the PVC pipe decreased down to a male nursery hose type fitting. Tool shops sell metal fittings that convert standard line string to a similar string utilized on garden hoses.

Most likely what you’ll wind up with is a connector that will change over the 1-1/2″ PVC to 3/4″ male line. At that point a connector to change over the 3/4″ male line to a male nursery house fitting. They additionally make a cap that you can introduce on the finish of a nursery hose, you’ll need one of those. This cap should have an elastic nursery hose washer in it so it seals appropriately.

The PVC fittings must be stuck on so you’ll need to get some PVC pipe paste and more clean. You need to utilize the cleaner to eliminate the film and sparkle from the PVC line and fittings before you stick them. When you have them cleaned, simply apply a covering of paste to both the line and the fitting, slide the fitting on and wind it simultaneously. Hold the fitting tight for 60 seconds and it will be stuck firmly.

Cut a piece of line 30″ long and stick the line cap toward one side, and the PVC to pipe string connector on the opposite end. Apply a limited quantity of line dope or Teflon tape to the strings of the connector, and screw the male nursery house fitting onto the connector. Screw the nursery hose cap to the male nursery hose fitting.

Presently back to the furthest limit of the line that you stuck the line cap to. Drill an exceptionally little opening right in the center of the line cap. You may need to explore a little with the size of the opening you need, yet ensure you start with a little opening. I’d start with 1/16″. Cut a piece of normal family wipe in a square around 1-1/2″ square. What you will do is place this wipe over the little opening you bored in the line cap, and secure it there by covering it with a piece of lightweight screen or cross section material. Perhaps a piece of an onion sack. You can tie down the cross section to the PVC pipe with a hose clip, or electrical tape.

By admin

Leave a Reply

Your email address will not be published. Required fields are marked *